Change #13

Connector connector

• summary set to "Mating plug-and-socket pair that joins two lengths of wiring or a cable to a board so a circuit can be assembled, serviced, and separated without soldering."

Bare PCB pcb-bare

• summary set to "Unpopulated printed circuit board: copper traces etched on an FR-4 glass-epoxy laminate that carry current between the components later soldered to it."

Microcontroller mcu

• summary set to "Single-chip microcontroller combining a processor core, flash memory, RAM, and peripherals such as timers, ADCs, and serial ports to run the device's control firmware."

Wire Bundle wire-bundle

• summary set to "Group of insulated conductors cut to length, terminated, and bound together to carry power and signals between the assemblies of a machine."

Relay relay

• summary set to "Electromechanical switch in which a small coil current closes or opens contacts rated for a much larger load, isolating control circuits from what they switch."

SMD Passive (R/C/L) smd-passives

• summary set to "Surface-mount resistors, capacitors, and inductors, typically in 0402 to 1206 packages, that set voltages, filter noise, and time signals on a circuit board."

Neodymium Magnet neodymium-magnet

• summary set to "Sintered neodymium-iron-boron permanent magnet, the strongest commercial magnet type, used for motor rotors, sensors, latches, and speakers."

Copper Winding copper-winding

• summary set to "Insulated copper conductor wound into coils that carry the phase current and create the magnetic field in a motor, generator, or transformer."

LCD Panel lcd-panel

• summary set to "Liquid-crystal display module with backlight and driver electronics that shows the machine's readouts, menus, and status to the operator."

Rotor Assembly rotor-assembly

• summary set to "Rotating member of an electric motor: a laminated steel core carrying permanent magnets or conductor bars, pressed onto a shaft that delivers the torque."

Rotor Shaft rotor-shaft

• summary set to "Hardened steel shaft at the centre of a motor rotor that carries the core, runs in the bearings, and transmits torque to the load."

Rotor Core rotor-core

• summary set to "Stack of thin electrical-steel laminations that forms the magnetic body of a motor rotor and holds its magnets or conductor bars."

Stator Assembly stator-assembly

• summary set to "Stationary part of an electric motor: a slotted laminated core wound with copper coils that produce the rotating magnetic field."

Stator Core (laminations) stator-core

• summary set to "Stack of slotted electrical-steel laminations, insulated from each other to limit eddy currents, that carries the stator windings of a motor."

Slot Insulation stator-insulation

• summary set to "Slot liners and phase paper that electrically separate the copper windings from the stator core and from each other."

O-Ring Set oring-set

• summary set to "Set of elastomer rings seated in grooves to seal static or slow-moving joints against fluid and gas, sized to ISO 3601."

Power Supply power-supply

• summary set to "Unit that converts mains or battery input into the regulated DC voltages a machine's electronics and actuators need."

Helical Gear Pair gear-pair

• summary set to "Two meshing helical gears forming one reduction stage that steps torque up and speed down between parallel shafts with quiet, continuous tooth contact."

Motor Housing motor-housing

• summary set to "Cast or extruded aluminium shell that carries the stator, locates the bearings, and conducts heat away from an electric motor."

Oil Seal oil-seal

• summary set to "Spring-loaded rotary lip seal that keeps lubricant inside a housing and dirt out where a shaft passes through, sized to DIN 3760."