Radio Board
AssemblyThe single PCB doing everything electronic: a network processor with an 802.11-derived 2x2 MIMO radio, front-end modules raising transmit power to outdoor limits, and a GPS receiver for synchronized variants. A full specification article for this item is being written. Meanwhile its bill of materials and connections are below.
Bill of materials for Radio Board
7 top-level lines as of r191035| # | Item / sub-assembly | Part no. | Qty/assy | Ext. qty | Parts | Type |
|---|---|---|---|---|---|---|
| 1 | Bare PCB | pcb-bare | 1× | 1 | · | part |
| 2 | Radio SoC | wireless-bridge-radio-soc | 1× | 1 | · | part |
| 3 | Front-End Module | wireless-bridge-fem | 2× | 2 | · | part |
| 4 | DDR Memory | wireless-bridge-ddr | 1× | 1 | · | part |
| 5 | Firmware Flash | wireless-bridge-flash | 1× | 1 | · | part |
| 6 | RF Shield Can | wireless-bridge-rf-shield | 2× | 2 | · | part |
| 7 | SMD Passive (R/C/L) | smd-passives | 160× | 160 | · | part |