Cooling Station
AssemblyThe chilled clamp jaws that hold the fresh weld under pressure while it sets, so the seal does not pull apart before the pouch leaves the dial. A full specification article for this item is being written. Meanwhile its bill of materials and connections are below.
Bill of materials for Cooling Station
4 top-level lines as of r162830| # | Item / sub-assembly | Part no. | Qty/assy | Ext. qty | Parts | Type |
|---|---|---|---|---|---|---|
| 1 | Cooling Jaw | spout-pouch-capper-cooling-jaw | 2× | 2 | · | part |
| 2 | Cooling Cylinder | spout-pouch-capper-cooling-cylinder | 1× | 1 | · | part |
| 3 | Water Block | spout-pouch-capper-water-block | 1× | 1 | · | part |
| 4 | O-Ring Set | oring-set | 1× | 1 | · | part |