Industrial Steam Press

Overview

An industrial steam press finishes garments by clamping them between a padded lower buck and a heated upper head, injecting steam through both faces to relax the fabric, and then pulling vacuum through the buck to set and dry the press. The combination of heat, moisture and pressure produces a sharp, durable finish far faster than hand ironing, which is why presses anchor the finishing line in laundries and apparel factories. This unit carries its own steam generator, so it needs only electricity and shop air to run.

The garment is laid on the Steam Buck, a contoured form with internal steam chambers, an auxiliary heater and a replaceable woven cover over heat-resistant padding. The Steam Head is the heated upper platen that closes onto it.

How it works

Steam comes from the Steam Generator, a pressure vessel heated by immersion elements and kept topped up by a feed pump under control of a pressure switch, with a safety relief valve and a dry-fire thermal cutoff. From there the Steam Circuit routes steam through solenoid valves and braided hoses to the head and buck on operator demand.

The press is closed by the Press Closure: a double-acting pneumatic cylinder drives an over-center toggle linkage that multiplies air pressure into clamping force, and return springs lift the head when air is released. The operator works the Foot Control pedals, keeping both hands free to position the garment.

After steaming, the Vacuum System system draws air through the perforated buck to extract residual steam and dry the fabric so the crease holds. The Control System system ties it together, switching heaters, valves, pump and blower through relays, holding platen and buck temperature via thermostats and thermocouples, and timing the press and steam cycle.