Clamp and Bend Dies
AssemblyThe tooling around the tube: a grooved bend die, a clamp die that holds the tube to it, and pressure and wiper dies that support the outside and inside of the bend. A full specification article for this item is being written. Meanwhile its bill of materials and connections are below.
Bill of materials for Clamp and Bend Dies
6 top-level lines as of r101949| # | Item / sub-assembly | Part no. | Qty/assy | Ext. qty | Parts | Type |
|---|---|---|---|---|---|---|
| 1 | Bend Die | mandrel-tube-bender-bend-die | 1× | 1 | · | part |
| 2 | Clamp Die | mandrel-tube-bender-clamp-block | 1× | 1 | · | part |
| 3 | Pressure Die | mandrel-tube-bender-pressure-die | 1× | 1 | · | part |
| 4 | Wiper Die | mandrel-tube-bender-wiper-die | 1× | 1 | · | part |
| 5 | Clamp Cylinder | mandrel-tube-bender-clamp-cylinder | 2× | 2 | · | part |
| 6 | O-Ring Set | oring-set | 1× | 1 | · | part |