Control System
AssemblyRuns the cycle: a VFD sets the bowl frequency and so the amplitude, a timer ends the cycle, a contactor switches power, and the HMI holds the recipes for each part and media combination. A full specification article for this item is being written. Meanwhile its bill of materials and connections are below.
Bill of materials for Control System
8 top-level lines as of r184636| # | Item / sub-assembly | Part no. | Qty/assy | Ext. qty | Parts | Type |
|---|---|---|---|---|---|---|
| 1 | Variable-Frequency Drive | vibratory-finishing-bowl-vfd | 1× | 1 | · | part |
| 2 | Motor Contactor | vibratory-finishing-bowl-contactor | 1× | 1 | · | part |
| 3 | Controller Board 5 parts | vibratory-finishing-bowl-controller-board | 1× | 1 | 0 | assembly |
| 4 | HMI Panel 4 parts | vibratory-finishing-bowl-hmi | 1× | 1 | 0 | assembly |
| 5 | Power Supply | power-supply | 1× | 1 | · | part |
| 6 | Relay | relay | 4× | 4 | · | part |
| 7 | Connector | connector | 6× | 6 | · | part |
| 8 | Wire Bundle | wire-bundle | 1× | 1 | · | part |