Table and Slides
AssemblyThe worktable moves in only two directions: longitudinally along the bed (X) and crosswise on a saddle (Y). Vertical cutting depth comes from the spindle head, not the table, which keeps the table low and rigidly supported. A full specification article for this item is being written. Meanwhile its bill of materials and connections are below.
Bill of materials for Table and Slides
7 top-level lines as of r12887| # | Item / sub-assembly | Part no. | Qty/assy | Ext. qty | Parts | Type |
|---|---|---|---|---|---|---|
| 1 | Worktable | btm-worktable | 1× | 1 | · | part |
| 2 | Saddle | btm-saddle | 1× | 1 | · | part |
| 3 | Cross Way | btm-cross-way | 2× | 2 | · | part |
| 4 | Table Wiper | btm-table-wiper | 4× | 4 | · | part |
| 5 | Ball Bearing | ball-bearing | 4× | 4 | · | part |
| 6 | Chip Tray | btm-chip-tray | 1× | 1 | · | part |
| 7 | Fastener Set | fastener-set | 1× | 1 | · | part |