Turret and Milling Head
AssemblyThe turret at the top of the column lets the head swing over the table, and the milling head itself tilts and nods. This articulation, the signature of the Bridgeport-style mill, lets the operator angle the spindle for compound cuts. A full specification article for this item is being written. Meanwhile its bill of materials and connections are below.
Bill of materials for Turret and Milling Head
10 top-level lines as of r94087| # | Item / sub-assembly | Part no. | Qty/assy | Ext. qty | Parts | Type |
|---|---|---|---|---|---|---|
| 1 | Turret | km-turret | 1× | 1 | · | part |
| 2 | Ram | km-ram | 1× | 1 | · | part |
| 3 | Head Body | km-head-body | 1× | 1 | · | part |
| 4 | Spindle | km-spindle | 1× | 1 | · | part |
| 5 | Head Motor | km-head-motor | 1× | 1 | · | part |
| 6 | Drive Belt | drive-belt | 1× | 1 | · | part |
| 7 | Spindle Taper | km-spindle-taper | 1× | 1 | · | part |
| 8 | Drawbar | km-drawbar | 1× | 1 | · | part |
| 9 | Ball Bearing | ball-bearing | 3× | 3 | · | part |
| 10 | Oil Seal | oil-seal | 1× | 1 | · | part |