Leg Forming Station
AssemblyBends the two ends of the spring into radial legs at the programmed angle, then cuts the spring free from the wire. A full specification article for this item is being written. Meanwhile its bill of materials and connections are below.
Bill of materials for Leg Forming Station
9 top-level lines as of r173978| # | Item / sub-assembly | Part no. | Qty/assy | Ext. qty | Parts | Type |
|---|---|---|---|---|---|---|
| 1 | Leg Bend Arm | torsion-spring-coiler-bend-arm | 2× | 2 | · | part |
| 2 | Leg Bend Tool | torsion-spring-coiler-bend-tool | 2× | 2 | · | part |
| 3 | Leg Radius Mandrel | torsion-spring-coiler-leg-mandrel | 1× | 1 | · | part |
| 4 | Leg Index Table | torsion-spring-coiler-index-table | 1× | 1 | · | part |
| 5 | Cut-off Slide | torsion-spring-coiler-cutoff-slide | 1× | 1 | · | part |
| 6 | Cut-off Blade | torsion-spring-coiler-cutoff-blade | 2× | 2 | · | part |
| 7 | Servo Motor 4 parts | servo-motor | 2× | 2 | 0 | assembly |
| 8 | Pneumatic Cylinder | pneumatic-cylinder | 1× | 1 | · | part |
| 9 | Ball Bearing | ball-bearing | 4× | 4 | · | part |