Browse products

Roll Stand

Assembly

Pair of horizontal roll shafts carrying the segmental dies; the rolls counter-rotate so the gripped billet end is drawn through the closing gap and reduced in section pass after pass.

Direct parts	8
Class	Assembly

Pair of horizontal roll shafts carrying the segmental dies; the rolls counter-rotate so the gripped billet end is drawn through the closing gap and reduced in section pass after pass. A full specification article for this item is being written. Meanwhile its bill of materials and connections are below.

Bill of materials for Roll Stand

8 top-level lines as of r68409

#	Item / sub-assembly	Part no.	Qty/assy	Ext. qty	Parts	Type
1	Roll Shaft	forging-roll-machine-roll-shaft	2×	2	·	part
2	Die Segment	forging-roll-machine-die-segment	4×	4	·	part
3	Die Clamp	forging-roll-machine-die-clamp	4×	4	·	part
4	Stand Housing	forging-roll-machine-stand-housing	2×	2	·	part
5	Screw-Down Unit	forging-roll-machine-screw-down	2×	2	·	part
6	Thrust Block	forging-roll-machine-thrust-block	2×	2	·	part
7	Ball Bearing	ball-bearing	8×	8	·	part
8	Oil Seal	oil-seal	6×	6	·	part